Caring for my Sleep+ Mattress and Fit Covers?

Have more questions? Submit a request

Revitalising King Sleep+ Mattresses

To clean and rejuvenate your Sleep+ Mattress, follow these steps:

  • Simply unzip and remove the top Comfort Layer and carefully vacuum inside the mattress using the upholstery cleaning tool. For localised soiling, immediately treat the affected area.
  • The Fit Covers can be unzipped and washed separately when needed (see instructions below).

Washing Sleep+ Fit Covers

To cleanse or refresh Fit Covers, adhere to the following steps:

  • Detach Fit Covers from the mattress and hand wash in warm water using a neutral wool detergent.
  • When needed, Fit Covers can be machine washed on a gentle cycle, at 40°C/104°F (30°C/ 86°F for WarmFit). For WarmFit Covers, make sure to disconnect controller switch(es) prior to cleaning.
  • Fit Covers can be tumble dried on a cold setting for a maximum of 15 minutes or line dried over a clothesline.
  • Avoid using pegs on WarmFit heating wires.
  • Do not bleach, dry clean, or iron Fit Covers.
  • Always ensure the connections to WarmFit Covers are kept moisture-free.

Cleaning Fit Covers

When soiling occurs, treat the affected area by following these steps:

  • Gently sponge with a natural wool detergent or mild soap flakes in lukewarm water,
  • Rinse twice with clean lukewarm water.
  • Gently squeeze the treated area between two towels to remove excess water, and lay flat to dry in a shaded area.
  • Fit Covers should not be hung to dry. For WarmFit Covers, disconnect controller switch(es) prior to cleaning.
  • Pilling might occur naturally but it does not impact the fabric's comfort or functionality.

Articles in this section

Was this article helpful?
0 out of 5 found this helpful